When providing a precise seal can mean the difference between an efficient operation or thousands of dollars in damaged equipment and downtime, you need the new Spearhead 748 E-25 Gasket Cutter. This new tool is perfect for economic, on-site cutting of round gaskets, washers, disks or diaphragms from 1” through 25” in diameter. The innovative features of the Spearhead 748 E-25 make cutting any pliable material through 1/2" thick easier and more precise because each component and body part has been machined to necessary close
tolerances to prevent a “doubling effect” over the course of the cutting motion. (i.e. 1/32” would double to 1/16” by the end of the cutting motion)
Each Spearhead 748 E-25 comes complete with these innovative components:
- A 12” x 12” x 1/2” thick Cutting Workboard,
designed and engineered for years of use in the
|
toughest working environment, contains both a center ferrule for cutting up to 13” diameters and a corner ferrule for cutting up to 25” diameters. The rugged,
Molded Pad is embossed with the Non-slip surface and compounded to “re-seal” itself, reduce blade friction and dulling.
- Extension Arm increases cutting capacity from 13” to 25”.
- Three thin blades for general purpose cutting and three thick blades for cutting tough or thick materials such as compressed asbestos are specially designed for maximum cutting depth.
- Short and long pivot pins allow for cutting material through 1/2” thick. Disk pivot pin for cutting disks.
- Spring-loaded Pin Handle for quick and easy
insertion of pivot pins through material.
ZIMMERMAN
PACKING & MFG., INC. |
748-E-25 Economy Gasket Cutter
